Ara
Toplam kayıt 40, listelenen: 1-10
Prediction for the Solid Waste Composition by use of Different Curve Fitting Models: A Case Study
(IEEE, 2015)
This study presents a methodology for the prediction of solid waste composition in the urban area based on a set of limited samples. The methodology was applied by a case study for Eskisehir city in Turkey. For this purpose, ...
Pyrolysis of Printed Circuit Board Waste With the Addition of Certain Common Waste Materials
(Parlar Scientific Publications (PSP), 2017)
Every year in Europe, 8.7 million tons of electronic waste is produced, with annual electrical and electronic equipment waste (WEEE) generated in Turkey at 539,000 tons. Most of the WEEE is comprised of printed circuit ...
An evaluation of the bottom ashes from healthcare waste in a laboratory scale incinerator: Microbiology, mutagenicity and toxicity
(Parlar Scientific Publications (PSP), 2006)
In this study, experiments of healthcare waste incineration at 500, 600, 700, 800 and 900 degrees C in a lab-scale incinerator were carried out, performing different total bacterial counts for the microorganisms in bottom ...
Modified orange peels for the recovery of silver from waste printed circuit boards
(Agro Arge Danışmanlık San Ve Tic As, 2016)
In this study, it was focused on the silver adsorption from PCB by biosorbents derived from orange peels. In this content, orange peels (OP) were modified by different methods including saponification with NaOH (OP-S), ...
Comparison of Different Modeling Methods of Copper Adsorption by Modified Orange Peels
(Agro Arge Danışmanlık San Ve Tic As, 2016)
Copper (Cu) which has higher electrical and thermal conductivity is an essential element in different sectors. Also, wastes occurred in these sectors contains copper in high amounts. For instance, printed circuit boards ...
Cadmium stabilization via sequential application of phytoremediation and pyrolysis
(Pamukkale University, 2016)
The objective of this study is the treatment of cadmium (Cd) contaminated soil and stabilization of cadmium (Cd) in a solid product. For this aim, phytoremediation and pyrolysis were sequentially applied. Phytoremediation ...
An evaluation of railway passenger transport in Turkey using life cycle assessment and life cycle cost methods
(Pergamon-Elsevier Science LTD, 2015)
In recent years, Turkey's railway transport system has shown considerable improvement. Today, our country has 12,000 km total rail network; the High Speed Railway (HSR) accounts for 888 km, with the remainder being ...
Evaluation of solid product obtained from tire-derived fuel (TDF) pyrolysis as carbon black
(Springer, 2015)
The main focus of this study was quality improvement of solid product obtained from tire-derived fuel (TDF) pyrolysis to use it as a substitute for commercial carbon blacks. First of all, TDF samples were analyzed by means ...
Life cycle assessment of solid waste management options for Eskisehir, Turkey
(Pergamon-Elsevier Science LTD, 2009)
Life cycle assessment (LCA) methodology was used to determine the optimum municipal solid waste (MSW) management strategy for Eskisehir city. Eskisehir is one of the developing cities of Turkey where a total of approximately ...
Orange Peel-Derived Pectin Jelly and Corn Starch-Based Biocomposite Film with Layered Silicates
(Wiley-Blackwell, 2014)
Orange peel-derived pectin jelly/corn starch-based biocomposite films with and without layered silicates (LSs) were prepared using melt extrusion followed by film die casting. To enhance interfacial compatibility, corn ...